Advanced Settings; Timer Set Up - L&S MEC MODULE SMART 4 EMOTION/EDC Guia De Inicio Rapido

ADVANCED SETTINGS

TIMER SET UP

Default setting: no timer
This procedure is used to set up a timer for lights before an automatic switch-off.
NOTE: don't use this procedure with SMART SENSOR, the controller already has a procedure to set the automatic switch-off of a light
PROCEDURE:
STEP 1
Press hidden button 'A' with paper clip
shortly. All LEDs turn on.
STEP 2
Within 10 seconds press button 1 or 4. LED light
starts to flash. Each flash corresponds to a different
timing.
STEP 3
Count the flashes and press button 4 shortly when you reach the number of flashes corresponding to the desired
timing. The led turns off.
LED
INDICATOR
1
2
3
4
5
6
7
8
MEC MODULE SMART 4
TIMER
1 minute
3 minutes
5 minutes
15 minutes
30 minutes
1 hour
18 hours
No timer
PRESS BUTTON SHORTLY
THE LED TURNS ON
PRESS BUTTON SHORTLY
LED STARTS FLASHING
PRESS SHORTLY AFTER DESIRED
THE LED TURNS OFF
1 2 3 4
A
1 2 3 4
A
FLASHES/TIMER SETTING
1 2 3 4
A
EN 6