LAUNCH TECH X-PROG 3 Guia De Inicio Rapido página 5

Connection & Operations
1. Preparation
Before diagnosing, please make sure the following conditions are met:
1). The ignition is turned on.
2). The vehicle battery voltage range is 11-14Volts.
3). Locate the vehicle's DLC port.
For passenger cars, the DLC is usually located 12 inches away from the center of the
instrument panel, under or around the driver's side for most vehicles. For some vehicles with
special designs, the DLC may vary. Refer to the following figure for possible DLC location.
If the DLC cannot be found, refer to the vehicle's service manual for the location.
2. Connection (When performing Diagnostics / Key Immobilizer operations)
For vehicles equipped with OBD II diagnostic socket, connect the VCI device to the
vehicle's DLC via the included diagnostic cable.
*Fo r no n - O BD I I v e h i c l e s , a n o n - 1 6 pi n c o nn e ctor(adap tor) is required.
Refer to the User Manual for more detailed connection method.
A. Opel, Volkswagen, Audi
B. Honda
C. Volkswagen
D. Opel, Volkswagen, Citroen
E. Changan
F. Hyundai, Daewoo, Kia, Honda, Toyota, Nissan,
Mitsubishi, Renault, Opel, BMW, Mercedes-Benz,
Mazda, Volkswagen, Audi, GM, Chrysler,
Peugeot, Regal, Beijing Jeep, Citroen and most
prevailing models
3. Key Immobilizer & Immobilizer Programming
1). Immobilizer
This function enables you to perform the anti-theft key matching function, so that the
immobilizer control system on the car identifies and authorizes remote control keys
to normally use the car.
2). Immobilizer Programming
This function allows you to perform the following functions:
1). Read key transponder data, and generate exclusive keys.
2). Read/write on-board EEPROM chip data, and read/write MCU/ECU chip data.
4. Diagnostics
1). Intelligent Diagnose
This function allows you to use the VIN information of the currently identified vehicle
to access its data (including vehicle information, historical diagnostic records) from
the cloud server to perform quick test, eliminating guesswork and step-by-step
manual menu selection.
2). Local Diagnose
Use this function to diagnose a vehicle manually. For new users, please follow the
operation chart shown below to get familiar with and start using this tool.
Tap Local Diagnose
Select vehicle software
3). Remote Diagnose
This function helps repair shops or mechanics to diagnose a remote vehicle, and
launch instant messages, allowing for improved efficiency and faster repairs.
Follow the prompts on the screen
Select software version