Product Usage; Selection Of Installation Equipment - Kunft KIH3300 Manual De Instrucciones

2.2. Product usage

Selection of installation equipment

Cut out the work surface according to the sizes specified in the
drawing below.
There must be a minimum 5-cm space around the hole for installa-
tion and use purposes.
Be sure the thickness of the work surface is at least 30 mm. Please
select a heat-resistant work surface material to avoid larger deforma-
tion caused by the heat radiation from the hotplate.
L (mm) W (mm) H(mm) D (mm) A (mm) B (mm) X (mm)
590 520 55
Always make sure the Induction hob is well ventilated and the air
inlet and outlet are not blocked. ensure the Induction cooker hob is
in good working order, as indicated below.
Note: The safety distance between the hotplate and the cup-
board above the hotplate should be at least 760 mm.
Before installing the hob, make sure that
• The work surface is upright and leveled, and no structural parts can
interfere with the space requirements;
51 560 490 50 min.
A (mm) B (mm) C (mm)
760 50 min. 20 min.
D E
air intake air exit 5mm
14
induction hob
• The work surface is made of a heat-resistant material;
• If the hob is installed above an oven, the oven has a built-in cooling
fan;
• The installation complies with all applicable requirements, rules and
regulations;
• There is a suitable isolating switch providing full disconnection
from the mains power supply incorporated in the permanent wiring,
mounted and positioned to comply with local safety rules and re-
gulations;
• The isolating switch must be of an approved type and provide a
3-mm contact gap in all poles (or in all live conductors, if local regu-
lations allow this variation);
• The isolating switch must be easily accessible to the user after the
hob is installed;
• Local building authorities and by-laws should be referred to, if there
are doubts regarding the installation;
• Heat-resistant and easy-to-clean finishes (such as ceramic tiles)
are used on the wall surfaces surrounding the hob.
After the hob is installed, make sure that
• The power supply cable is not accessible through cupboard doors
or drawers;
• There is an adequate flow of fresh air from outside the cabinetry to
the base of the hob;
• If the hob is installed above a drawer or cupboard, a thermal protec-
tion barrier is installed below the base of the hob;
•The isolating switch is easily accessible by the user.
Before fixing the brackets
The unit should be placed on a stable, smooth surface (use the pa-
ckaging). Do not apply force onto the controls protruding from the
hob.
Adjusting the position of the brackets
fix the hob on the work surface by screwing the 4 brackets on the
bottom of the hob (see picture) after the installation.
EN
KIH3300
A B
Screw Bracket
C D
Screw hole Base
15