Assembly Instructions - Style selections SGY-GHR1 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

Install Mounting Rail to Masonry Wall
1. Position the mounting rail (D) on the wall at a
convenient height.
2. Use a level to ensure the mounting rail (D) is
horizontal.
3. Mark hole center locations on the wall.
WARNING Ensure there are no live electric
wires or plumbing in the wall where you mount
the hose reel. Always use eye-protection when
using power tools.
4. Using a 1/2" (13 mm) masonry drill bit, drill
on the marks you made in step 3.
5. Using a hammer, lightly tap the masonry
anchors into the holes, being careful not to
damage them, until fully seated. Remove the
nuts and washers.
NOTE Keep the nut at the top of the threads
while you are tapping the masonry anchor in.
6. Hang the mounting rail (D) onto the exposed
anchors.
7. Replace the nuts and washers, tightening
them with a wrench or socket.
Hardware Used
AA
x 4
1
2
5
D