Locking tab
Locking
screw
Cleaning the standard roller
The standard roller should be cleaned every four to five uses. A groove is provided for this
purpose.
Use a blade or a pair of scissors to gradually cut any hair or debris clogging up the roller,
taking care not to damage the integrated bristles.
Cleaning the special hard floor roller
To clean the hard floor roller, use a pair of scissors or a blade to cut hair and other
obstructions, taking care not to cut or damage the roller bristles.
28
Cleaning
groove
use
Before using the vacuum cleaner, make sure that
•
the filters are installed correctly into the body
of the appliance. Refer to the "Cleaning and
maintenance" section.
Never use the appliance without the filter or dust
•
container!
"Boost" function
1.
The vacuum cleaner has two speeds. Press the On/Off button (6) on the handle once
(see above diagram). The appliance turns on and the charge level indicator turns on.
2.
To increase the suction power in particularly dirty areas that require deeper cleaning,
you can activate the "Boost" function by pressing the "Boost" button (5).
3.
The battery will last for 25 minutes on normal speed, whereas on "Boost", it will last for
12 minutes (if the battery is fully charged).
4.
The brush is equipped with LEDs for better visibility in dark spaces.
5.
Your vacuum cleaner's hose is foldable: press the sectioning button for greater
manoeuvrability.
6.
When you have finished, press the On/Off button to turn off the vacuum cleaner.
7.
If necessary, empty and clean the dust container and filters (See the "Cleaning and
maintenance" section).
8.
Place the vacuum cleaner on the charging base to charge it.
On/Off switch
29