Cleaning The Upper Housing Of The Appliance - Venta ORIGINAL LW15 Manual De Instrucciones

1
3
5
1
3
4
2
24 EN
2
4
2
1
3
4
6
5
6
3
2
1
4
CLEANING THE UPPER HOUSING
OF THE APPLIANCE
Attention!
Ensure the appliance is switched off during all actions and the
!
power supply unit is disconnected from the power outlet!
01
Detach upper housing from lower housing. Press locking buttons so that
the ends stand up.
02 Fold side parts out of the way.
03
Fold ribbed wings out of the way.
04
Unplug the power supply unit from the motor
out . Disconnect the power supply unit cable by releasing the bracket
2
and pull downward and out through the opening of the upper housing
∙ Do not disassemble the motor and the power supply unit, im-
!
merse them in water or bring them into contact with liquids!
∙ Only clean the motor with fan blades and gear with a dry cloth!
∙ The disassembled upper housing can be cleaned under run-
ning water!
∙ The disassembled upper housing must be absolutely dry be-
fore assembly!
05 Insert the motor into the upper housing from the correct side
power supply unit from the bottom upwards and through the opening of the
upper housing and plug it into the motor until it clicks into place
2
the cable with the bracket .
4
06 The outer ends of the locking buttons must be standing up. Fold the ribbed
side wings and upwards, then the side elements
1 2
on the outer ends of the locking latches
ing correctly again.
. Lift the motor upwards and
1
3
.
4
. Pull the
1
. Affix
3
nd . Press down
3 a 4
and to close the upper hous-
5 6
EN 25