Operating Instructions - Style selections SGY-GHR2 Manual Del Usuario

OPERATING INSTRUCTIONS

WARNING: Always hold the hose reel until it completely retracts into the hose reel.
WARNING: The yellow tape marks the end of hose length.
WARNING: Release pressure when not in use.
CAUTION: Do not release the hose allowing to rewind on its own.
1. Pull the hose out to the desired length. The hose will automatically lock in position.
2. To unlock and retract, give the hose a short pull. Walk the hose back to the hose
reel. If you pull the hose longer than 4" (10 cm) you may re-lock the hose.
3. To avoid injury and damage, always hold the hose while it is retracting. This hose
reel has a controlled return function.
4. If the hose becomes tangled and will not retract - slowly pull out the hose past the
tangled section and then allow the hose to slowly retract while guiding the hose
back into the hose reel. Always ensure the hose is clean and not twisted.
4
ADJUSTING THE STOP-BALL
The stop-ball location can be adjusted to ensure the hose is always within reach.
Recommended tools
No tool is needed.
1. Pull out the hoes to the desired length, ensuring
the hose reel is locked (will not rewind).
2. Open the latch on the stop ball (B) and move it
to the desired location.
3. Re-latch the stop ball (B).
CAUTION: always make sure the hose reel is
locked before removing the stop ball, and make
sure the stop ball is securely fastened before
unlocking the reel.
5
7
B