Berner 169091 Manual Del Operador página 7

Functions
(Page 2)
1. ON/OFF
2. Origin resetting
3. Metric / Inch conversion
4. remo–veable thumbroll
5. Battery-cover
6. Fixing screw
Specifications:
Measuring range: 0 – 150 mm/6" /
max. operational speed: ± 1.5 m/sec.
Repeatability: ± 0.01 mm
Storage temperature: 0 °C – 40 °C
Battery replacement:
Open battery cover to the bottom carefully. Remove the old battery.
Replace the battery with the positiv (+) facing up into the battery compartment.
Now close the battery cover very carefully.
Notes:
Please prepare with measuring very carefully. Keep surfaces clean. The caliper
should be regularly cleaned with cotton-cloth. Do not use petrol. Do not expose
the caliper direct to the sun light, ultraviolet rays or extreme temperatures.
Prevent it from any shock and do not immerse the caliper in any liquid.
Electric etching or engraving by high voltage can destroy the
electronic chip, no warranty will be given!
Never dismantle the caliper housing. The battery should be taken out, if no
use for a long time. Do not give used batteries in refuse. Please give it to a
special collecting depot.
Electr. digital caliper
Operation manual
:
0 – 200 mm/8" /
0 – 300 mm/12"
7. Display
8. Depth Gauge
9. Measuring jaws for outside
measurement
10. Measuring cross-tips for inside
measurement
11. Data output
Accuracy: ± 0.02 mm /
± 0.03 mm /
± 0.03 mm
Power supply: battery (3 V, type CR2032)
Resolution: 0.01 mm, 0.0005"
Humidity influence: 0 – 80 %
EN
6