Bosch GDE28D Instrucciones De Funcionamiento Y Seguridad página 8

2610067290 06-21 GDE28D.qxp_GDE18V-16 6/25/21 9:36 AM Page 8
Emptying the Dust Box
eyewear, gloves and dust protective
clothing. Dust box may contain crystalline
silica dust.
Reference Guide
Following table may be used as a guide to
determine how often the dust canister
should be emptied.
Hole size
½" diameter, 1½" deep
¼" diameter, 1½" deep
* Larger diameter holes or deeper holes will cause the
number of holes to vary.
Please inspect the filter 16 regularly for
damage and/or excessive dust accumulation.
Empty the dust box 9 after completing your
work or as needed.
REMOVING the dust box from the dust
extraction attachment:
1. Hold the power tool with the dust
extraction attachment horizontal and
switch on the power tool for a few
seconds. This will cause residual dust to
be cleared out of the extraction channel
into the dust box 9.
attachment to avoid release of crystalline
silica dust.
2. Press the release button 7, located on
the front of the dust box 9, to unlock the
dust box from the dust extraction
attachment (Fig. 7).
3. With the dust box 9 unlocked, slowly pull
the dust box downward from the dust
extraction attachment (Fig. 8).
NOTE: Keep the tool in a horizontal
drilling position to avoid spilling any of
the contents while pulling the dust box
out of the dust extraction attachment.
8
Operating instructions
Wear respiratory
protection, protective
Number of holes
~ 20*
~ 40*
Use caution removing
dust box from
FIG. 8
(16)
(9)
(7)
DISPOSING of the contents of the dust box:
disposing process, and always dispose
dust box contents in a closed plastic bag.
Improper disposal of silica dust may cause
a health hazard.
After removing the dust box from the dust
extraction attachment, follow these steps
for proper disposal:
A. Gently release the lock on the bottom of
the dust box empty flap, and carefully
place the dust box 9 inside a plastic bag.
It is important that the dust box is
completely covered inside the plastic
the
bag to keep any possible air-borne dust
inside. Turn the dust box over to empty
out the contents. Lightly tap the dust
box to assure all contents have been
removed. This light tapping will also
remove any large dust particles that
accumulated on the surface of HEPA
filter 16 (Fig. 9).
B. Remove the dust box from the plastic
bag and examine to assure the HEPA
filter 16 has been cleared of all
accumulated dust particles.
Replace the HEPA filter when collected
dust particles may not be removed from
the filter material. Damaged filter may
create a risk of exposure to crystalline silica
dust.
Do not create air-borne
dust during the