Bosch GDE28D Instrucciones De Funcionamiento Y Seguridad página 6

2610067290 06-21 GDE28D.qxp_GDE18V-16 6/25/21 9:36 AM Page 6
use this dust extraction attachment when
drilling with liquids or into wet materials.
Never use the dust extraction attachment
without a filter. If the dust extraction
attachment is used without a filter, larger
particles of drilling dust can be flung
towards the user and the power tool can be
damaged.
Only use an undamaged filter (no cracks,
small holes, etc.). Replace a damaged filter
immediately.
Never carry the power tool by the dust
extraction attachment.
Note: The guide 5 is spring-loaded. The guide
can spring forward when the button 6 for
drill bit length adjustment is pressed (Fig. 1).
Inserting/Removing
Drill Bits (Fig. 3)
- Press and hold the button 6 and pull the
guide 5 all the way outward.
- Release the button 6.
- Slide the tip of the drill bit through the
dust cap 3 from behind and then fit the
bit into the chuck according to the
instructions of your power tool.
- Before removing the drill bit, press the
button 6 again and pull the guide 5 all
the way outward.
Adjusting the Guide
Length (Fig. 4 & 5)
To ensure that dust is extracted cleanly and
the depth stop is set correctly, the guide 5
must be adjusted so that the tip of the drill
bit is flush at the front with the dust cap 2
or 3 (Fig. 5).
- Press and hold the button 6 and move
the guide 5 until the tip of the drill bit is
flush with the "crosshair" of the dust
cap 1.
- Release the button 6.
Note: To store the dust extraction
attachment, press the button 6 and pull the
guide 5 all the way outward. This relieves
strain on the guide's spring, which
increases the lifetime of the spring.
6
Operating instructions
To prevent damage to
the HEPA filter, do not
FIG. 3
1
2
(3)
(5)
FIG. 4
2
(6)
FIG. 5
(2)(3)
(2)(3)
(2)(3)
(6)
1