Assembly - AT 500BV Manual De Instrucciones

ASSEMBLY

NOTE: Place the packaging with the equipment on a level surface. It is recommended that you place a
protective cover for your floor. Exercise caution when you are loading and transporting equipment.
Unpack and assemble the equipment where it will be used.
If necessary, ask the help of someone else.
STEP 1
STEP 2
Attach the front stabilizer (17) and the rear stabilizer (24)
to the main frame (48) with bolt (17) and washer (16).
Attach the pedal (37L/R) to the crank arms as shown.
CAUTION: be sure the right pedal (37R) marked (R) is
attached to the right crank arm and tightened in the
clockwise direction. The left pedal (37L) marked (L) is
attached to the left crank arm and tightened in the
anticlockwise direction.
Attach the seat (27) to the seat post (28) with washer
(16) and nylon nut (30), then tighten seat (27). Slide the
seat post (28) into the vertical seat post (32) and at the
desired position, align holes and fix in place with the
locking knob (34) and washer (33). Insert the vertical
Seat Post (32) into the main frame (48) and line up the
holes. Secure the seat in position with the Adjustment
Knob (36). The correct height for the seat can be
adjusted after the bike is fully assembled.
7