THE MONITOR
FUNCTIONAL BUTTON:
MODE: Press MODE to select functions.
SET: To set value of time, distance and calories when not in scan mode.
RESET: Press to reset time, distance and calories.
Hold it for 3 seconds to reset time, distance and calories.
FUNCTION AND OPERATIONS:
1. SCAN: Press MODE button until "SCAN" appears, monitor will rotate through the following functions: time,
calories, speed, distance and total distance. Each display will be hold 4 seconds.
2. TIME (TMR): Count the total time from exercise.
3. SPEED (SPD): Display current speed.
4. DISTANCE (DST): Count the distance from exercise.
5. CALORIES (CAL): Count the total calories from exercise.
6. TOTAL DISTANCE (ODO): Count the total distance. This value is reset to zero, after installing the batteries.
7. PULSE RATE: Press MODE button until "©" appears. Before measuring your pulse rate, please place both your
palms on the contact pads and the monitor will show your current heart beat rate in beats per minute(BPM) on the
LCD after 3~4 seconds.
Remark: During the process of pulse measurement, because of the contact jamming, the measurement value may
be higher than the virtual pulse rate during the first 2~3 seconds, then it will return to normal level. The
measurement value is not valid as a medical information.
8. AUTO ON/OFF & AUTO START/STOP: Without any signal for 4 minutes, the power will turn off automatically.
When return the movement of the product or pressing the button, the monitor turn on again.
9. ALARM: The monitor will sound an alarm for 5 seconds if any value be above than value selected. Press MODE to
select the funtions and SET to adjust the value.
SPECIFICATIONS:
FUNCTION
OPERATING TEMPERATURE
STORAGE TEMPERATURE
AUTO SCAN
TIME (TMR)
CURRENT SPEED (SPD)
TRIP DISTANCE (DST)
CALORIES (CAL)
TOTAL DISTANCE (ODO)
PULSE RATE (©)
BATTERY TYPE
Every 4 seconds
0:00 ~ 99:59 (minutes:seconds)
The maximum pick-up signal is 999.9 km/h
0 ~ 999.99 km
0 ~ 9999 kcal
0 ~ 999.9 km
40 ~ 240 BPM (beat per minute)
2pcs AAA
0ºV ~ +40ºC
-10ºC ~ +60ºC
9