EINHELL TE-VC 36/30 Li S Manual De Instrucciones página 10

Air regulator (Fig. 2/Item 27)
The air regulator (27) can be fi tted between the
suction hose (10) and the suction tube (11).
The suction power of the nozzle can be infi nitely
adjusted using the air regulator (27).
When wet vacuuming, make selective use of the
air regulator to suck in air as well as liquids. This
will help to take some strain off the equipment
when vacuuming liquids.
5.4 Suction nozzles
Combination nozzle (Fig. 2)
The dual-purpose nozzle (12) is for vacuuming
solids and liquids over medium to large areas.
Crevice nozzle (Fig. 2)
The crevice nozzle (16) is designed for
vacuuming solids and liquids in corners, edges
and other areas that are diffi cult to access.
Upholstery nozzle (Fig. 2)
The upholstery nozzle (23) is specially designed
for vacuuming solids on upholstery and carpets.
Fitting the Lithium-Ion battery (not included)
(Fig. 16)
Flip up the battery cover (19) as shown in Figure
16. Slot the two rechargeable batteries into the
mounts. The device does not work with only one
battery
6. Operation
6.1 On/Off switch (Fig. 1/Item 2)
Switch position 0: Off
Switch position I: Vacuum setting 1 (ECO)
Switch position II: Vacuum setting 2 (BOOST)
6.2 Dry vacuuming
Use the pleated fi lter (18) for dry vacuuming
(see point 5.2). The dust bag (14) can be fi tted in
addition when removing particularly stubborn dirt
(see point 5.3).
Always ensure that the fi lters are securely seated.
6.3 Wet vacuuming
For wet-vacuuming, use the foam fi lter (15) (see
point 5.2).
Check that the fi lter is securely seated at all times.
Anl_TE_VC_36_30_Li_S_USA_SPK7.indb 10 Anl_TE_VC_36_30_Li_S_USA_SPK7.indb 10
EN
Water drain screw (Fig.1)
To make the tank (7) easier to empty after wet
vacuuming, it is fi tted with a water drain screw
(17).
Open the water drain screw (17) by turning it anti-
clockwise and drain the liquid.
When wet-vacuuming, the fl oating safety switch
(Fig. 4/Item 5) closes when the maximum tank
level is reached. At the same time, the suction
noise of the equipment will change and become
louder.
You must then switch off the equipment and
empty the tank.
Danger!
The wet/dry vacuum is not suitable for the
vacuuming of combustible liquids. For wet
vacuuming, use only the supplied foam fi lter.
6.4 Blowing
Connect the suction hose (10) to the blow
connector (9) on the wet/dry vacuum.
6.5 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.6 Battery capacity indicator (Fig. 21 / item
19)
Press the battery capacity indicator switch (40).
The battery capacity indicator (39) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temper-ature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
- 10 -
13.04.2022 14:00:33 13.04.2022 14:00:33