Keyboard - Gastrodomus TSD100 Manual Del Usuario

II. KEYBOARD
SET
Display the target set point outside of programming mode. In programming mode, select a
parameter or confirm an operation. Press the key to set Hds
(Up) Start or stop a manual defrost in a short time by pushing and releasing the key to see the
maximum value of the stored room temperature. In programming mode, the key increases
value and controls room temperature .
HARD Press and release the key to choose the Hard option (Program that optimizes chilling and
freezing times)
(DOWN) After the selected cycle and before the cycle starts press the key for 3 seconds the
cycle will switch between time mode and temperature mode . In programming mode the key
will decrease the value. Press and hold the key until the remaining time of the current phase is
shown when the timer mode cycle starts. (Show Phase : PH1 , PH2.. 1 S shows the time)
Press and release the button or pause the cooling cycle
Turning the unit ON/OFF (Press the button for 5 seconds) onF=Of
Press and release the button to turn on the light
CHILL Choose the chilling or freezing cycle: press the key until the display shows (cyS) choose the
desired cycle. Press the key for 3 seconds to stop the cooling cycle.
FREEZE
AUX Press and release the Aux key
Press the key for 2 seconds to see the temperature of the probe
LED MODE
ON
ON
ON
ON
CH ON
FR ON
HD ON
FUNCTION
Compressor Led
Defrosting activated
Fan On
An alarm/error is occurring
Cooling cycle is running
Freezing cycle is running
HARD Mode
18