Fcc Statement; Charging The Battery - DeWalt ATOMIC DW055PL Guia Del Usuario

FCC Statement

E
These devices comply with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: 1) this device may not cause
harmful interference, and 2) this device must
accept any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio and
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
4
Canada, Industry Canada (IC) Notices
Class B digital circuitry of this device complies
with Canadian ICES-003. This device complies
with Industry Canada license-exempt RSS
standard(s). Operation is subject to the
following two conditions: 1) this device may
not cause interference, and 2) this device must
accept any interference, including interference
that may cause undesired operation of the
device.

Charging the Battery

Fully charge the battery before initial use and
whenever the tool has not been used for 6
months or longer.
WARNING:
Only charge product using
a certified power adapter that is
compliant with applicable country
regulations and international/regional
safety standards. Using adapters
that do not meet applicable safety
standards could result in injury.
Locate the port cover on the bottom of the
1.
tool (Figure ).
A 4
Using your finger, gently pull the port cover
2.
up (Figure ).
C 1
Insert the small end of the USB Recharge
3.
Cable into the port on the bottom of the
tool, making sure to insert the flat side
of the cable into the flat side of the port
(Figure ).
C 2
Insert the USB end of the cable into a USB
4.
port in a computer or USB power outlet
(Figure ).
C 3
Wait approximately 2.5 hours for the
5.
battery to fully charge and then disconnect
the USB Recharge Cable.
When the tool is ON, the battery level appears
in the display window (Figure ).
D 1