Using The Tool - DeWalt ATOMIC DW055PL Guia Del Usuario

Using the Tool

Point the laser at the top of the tool (Figure
1.
) toward the wall whose distance you
A 1
need to measure (Figure
Click (Figure
2.
A 3
and display a laser dot on the wall (Figure
).
E 1
When the bottom of the tool is positioned
3.
at the correct distance from the wall, click
to take the measurement (Figure
).
E 2
View the measurement on the display
4.
window (Figure
D 3
Changing the Unit of Measure
Once the current measurement is taken, you
can change the unit of measure from decimal
ft (6.21 ft) to fractional ft (6'02"9/16), fractional
ft to meters (1.894 m), meters to inches (74
9/16 in), or inches to decimal ft.
To change the unit of measurement, press
and hold until you see the measurement
change (3 seconds).
NOTE: If you continue to hold
measurement changes, the tool will turn off.
Re-measuring
When you need to take a new
1.
measurement, point the laser toward the
wall whose distance you need to measure.
Click .
2.
• The previous measurement (Figure
) will be cleared from the display
D 3
window.
• will change to
window (Figure
D 2
).
E 1
) to turn the tool on
).
after the
in the display
).
When the bottom of the tool is positioned
3.
at the correct distance from the wall, click
to take the measurement (Figure
).
E 2
Turning Off the Tool
The tool can be turned off in either of these
ways:
• After taking a measurement, press and hold
for 5 seconds (until the display window
clears).
• If you do not use the tool for 120 seconds, it
will automatically turn off. (After 60 seconds,
the laser (red dot) will turn off and then after
another 60 seconds the unit will turn off.)
Warranty
Go to www.D WALT.com for the latest
E
warranty information.
E
5