2WD Buggy DAZZLER
Start-up
The battery and charger will get warm whilst charging.This is normal.
-
Do not charge on, or near to, a material/surface that is flammable or one that can be damaged by heat.
The battery can be re-charged approximately 500 times before it needs replacing.
When the battery no longer holds a charge(is dead), it should be properly recycled. Do not dispose of it in household
waste.
Charging time : 6 hours
Attaching the wheels to the chassis
-
Insert the drive pin through the drilling in the wheel axle
-
Push the wheel adapter onto the wheel axle and then put on the wheel
-
Lock each wheel with a lock nut on the wheel axle
Drive pin
Lock nut M8
No. 103003
09/06
All manuals and user guides at all-guides.com
How to charge the on-board battery
The on-board battery supplies the receiver as well as the on-board starter
and the electric motor for the reverse driving with the operating voltage.
-
Plug the supplied charger into a mains
outlet socket.
-
Connect the battery to charger as
indicated.
Do not force the connectors together-
they only attach one way !
The battery is not supplied pre-charged and
has to be charged fully before using
your Dazzler.
Only charge the battery when the fuel tank is empty!
Wheel adapter
Lock nut M8
29