How To Change Frequencies; Recommendations For Operation - Carson DAZZLER RTR Manual De Instrucciones

2WD Buggy DAZZLER

How to change frequencies

Make sure that nobody else is transmitting in the proximity of your frequency!
Interfering signals on the same frequency can make you lose control over your
model.
Crystal
The transmitter and receiver crystals must be of an identical frequency.
Make sure that the crystal is fully inserted in the transmitter and receiver, not partially.
Recommendations for controlling the model
Please remember that controlling RC model cars has to be learned step by step. Seek advice from an experienced R/C
user for the first few attempts.
- Start with an easy oval.
Arrange two cups as pylons and try to navigate the model around them.
- Then navigate an "Eight"
Remove the cups and use two visual fixed points to navigate around.
- Get used to the driving behaviour in curves.
- Keep in mind that the remote commands have to be given in the direction of the model.
Practice steering when the model runs towards you!
- Brake into the curves and accelerate out.
Engine
The 3-ccm engine is air-cooled (cooling through the air stream)
- Avoid short bursts of throttle and prolonged use of full throttle. These actions will not allow the engine to cool sufficiently
and could result in damage to the engine due to overheating.
If the engine is overheated, it could break down.
- Always drive with the appropriate rpm's.
Attention!
Driving slowly for a long time may cool the engine but can damage the clutch due to slipping.
Clutch
The power of the engine is transmitted to the differential gear in the rear axle.
- The clutch doesn't engage during low speed rotation, the model stands still with a running engine.
- As the RPM is slowly increased, the clutch engages and the vehicle begins to move forward.
If the clutch shoes slip, they can overheat and result in damage.
- At a higher RPM the clutch engages immediately and this provides the power to accelerate forward.
This method minimises the wear to the clutch linings
Bearing
Overheating of the engine and/or clutch can have a detrimental effect on the clutch bell bearings.
No. 103003
09/06
All manuals and user guides at all-guides.com
If you are driving with other Rc-users, it might
be necessary to change the frequency.
A rapid change of frequencies is possible simply
by unplugging an interchangeable crystal on the
back of the transmitter and then plugging in
Receiver
Plug in an interchangeable crystal into the recei-
ver for a rapid change of frequencies.
Transmitter
another one.
Crystal
33