Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks Pro EA80L00 Manual Del Operador

EN
8.1.2 INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.1.3

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

• Touch the bit carefully.
• Do not touch the bit unless you remove the battery pack.
• Do not use the machine if the bit is damaged or bent.
• Remove all objects such as cords, lights, wire, or string
which can become entangled in the bit and create a risk of
personal injury.
If the bit jams on an electrical cord or line, DO NOT
TOUCH THE BIT! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine down
and away from you.
2. Disconnect the electrically service to the damaged line
or cord before you try to free the bit.
4
WARNING
WARNING
English
9.1

START THE MACHINE

3
This machine has three lights along the bottom of the power
head around the shaft. When the trigger is pressed, the lights
turn on. If you release the trigger fully, the lights will turn off
after 30 seconds.
1. Press the safety lock-out switch (2).
2. Squeeze the trigger (1) to start the machine.
Keep the machine clear of water.
Do not touch the cap of the gear box after operating the
machine, the high temperature may cause the injury.
9.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.3

OPERATION TIPS

3
Before drilling a hole, always look to see what position the
forward/reverse switch is in.
• Push the forward/reverse switch (3) to "F" for forward.
The machine will rotate clockwise and drill down into the
ground. Shift your body weight above the bit to help it
drill.
8
1
2
WARNING
DANGER