Maintenance; Clean The Machine; Store The Machine; Troubleshooting - GreenWorks Pro EA80L00 Manual Del Operador

• Push the forward/reverse switch (3) to "R" for reverse.
The machine will rotate counterclockwise and attempt to
rotate out of the ground. Pull up on the handles when
drilling into the ground, this will allow the bit to go into
the ground and out of the ground easier. The reverse
function can also be used to help the bit unbind from a
root or other obstruction.
• When drilling a deeper hole, clear dirt/ material from the
auger bit occasionally by pulling the unit up 4 inches after
drilling down every 6 inches. This will make the auger
easier to remove once the hole has been completely
drilled.
• In thick clay or rocky soils the hole may need to be
drilled more slowly and the earth removed more often.
• If using in very cold conditions, the battery may need to
be warmed up for the auger to work. This can be done by
placing the battery in a warmer area (indoors, in a coat
pocket, etc.) for a couple of minutes.
WARNING
Hold the machine firmly with two hands at the same time
and do not loosen your grip before the machine stops.
Operate the machine in pairs if necessary.
10

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
English
10.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
11

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
12

TROUBLESHOOTING

Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
The motor is on,
the bit do not
move.
9
WARNING
NOTE
Possible cause Solution
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is Charge the battery
out of power. pack.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery pack.
3. Contact the
service center.
Do not use the ma-
The machine has
chine and contact
damage.
the service center.
Remove battery
The bit are pack then clear
blocked. blockage from the
bit.
EN