After Service; Storage And Transportation - 3TECH LED-3200 Manual De Usuario

8. Trouble Shooting
Fault
No indication, no response.
"Er" shown on the screen.
Wink shown on the screen.
Light intensity is weak.
The device is not charging
when the adapter is
connected.
The mode indicator twinkles
when charging.
If such handlings are completed, the
special maintenance

9. After service

From the date this equipment has been sold, based on the warranty card we will repair
this equipment free of charge if it has quality problems, please refer to the warranty card
for the warranty period.

10. Storage and transportation

– This equipment should be handled carefully, kept away from shaking point, installed or
stored at shadowy, dry, cool and ventilated places.
– Don't store it together with articles that are combustible, poisonous, caustic and explosive.
– Th is equipment should
is 10%-93%, the atmosphere pressure is 70 kPa to 106 kPa and the temperature is
-20° C to +55 °C.
– Excess impact or shake should be avoided during transportation.
– Don't mix it with dangerous articles during transportation.
– Keep it away from sun or snow or rain during transportation.
16
Possible cause
1. Battery is out of power.
2. Faulty of battery.
3. The main unit battery
protection system works.
1. System error.
2. Faulty of main unit.
Low battery.
There is resin on top
of the main unit.
1. The adapter is not well
connected.
2. Faulty of adapter or
incompatible.
3. The charging unit is dirty.
1. Low voltage.
2. Short circuit of the battery.
device
shop or our company.
be stored in the
1. Charge the device.
2. Send to after service for
repair.
3. Place the main unit into
the socket on the charger
for activation.
Send to after service
for repair.
Reconnect the charger, if
"Lo" show again after 15
minutes please send to after
service to repair.
Remove the resin.
1. Reconnect.
2. Change the adapter.
3. Clean with alcohol.
1. Back to normal after 15
minutes charging.
2. Send to after service for
repair.
still cannot work normally, please
environment where
Solutions
contact the
the relative humidity