Setup Menus - JBL SYNTHESIS SDR-38 Manual

Setup Menus

The Setup menus allow you to configure all aspects of your
Receiver. The next few pages will go through the menu items
accessible via the front panel, IR remote, or internal web
page and explain their function. The majority of the Setup
menus need only be configured once when you first install
the system (or if your system changes, you move any large
furniture or the listening locations, or you move).
Entering Setup mode
To enter the setup menu, press the button on the
remote control or font panel. The front panel display shows
the setup menu (pictured right).
Input Config
General Setup
Speaker Types
Speaker Distances
Speaker Levels
Navigating the setup menu
... using the remote control
The setup menu can be navigated by using the cursor
(arrow) keys on the remote control. This is by far the
easiest method.
1. To enter the setup menu, press the button (which is
located immediately under the navigation buttons).
2. Use the ' and , keys to navigate up and down the
main section headings.
3. Once you have the main section that you require
highlighted, use the > key to enter the section.
Video Inputs
HDMI Settings
Zone Settings
O
Network
Bluetooth
4. Use the ' and , keys to navigate up and down the
section settings in the right-hand panel. Some settings
may be greyed out. These are either for information only
(e.g. incoming sampling frequency) or are not currently
selectable. Scroll bars on the sides of the right hand panel
indicate your position in the settings list where there are
more items than can be displayed at once.
5. Pressing selects a setting to change it, pressing
again de-selects the setting.
6. At any time, press the button to exit the menu. Any
changes to settings are saved.
... using the keys on the front panel
The Receiver front panel controls can be used to configure
the unit. Follow the instructions for using the remote
control, in this case using for down,
for left and for right.
EN-30
....using the internal configuration web page
The units have an internal configuration page that
presents the same set up functionality front panel display
on a web browser.
This enables the unit to be set up and configured from any
browsing device connected to the same network as the unit.
To access the internal configuration page, find the units'
IP address by selecting Network >IP Address. Type the IP
address in the browser window.
The menu headings and function are the same in the
internal configuration page and the front panel and are
described below.
for up,