Error Codes - Samsung CM1919A Instrucciones Para El Usuario

jtX`X`h†l|TWYZ\Wi†luU”GGwˆŽŒG_GGt–•‹ˆ SGqˆ•œˆ™ GY_SGYWW_GGXXa\\Ght

Error Codes

EN
Erroe Items Code Error Beep
Power E1 One long beep
frequency Error for 2 sec
(50/60Hz)
Thermistor E21 One long beep
Open Error for 2 sec
Thermistor E22 One long beep
Short Error for 2 sec
Temperature of E3 One long beep
exhaust air too for 2 sec
High Error
HVT-I Power E41 One long beep
Error for 2 sec
HVT-II Power E42 One long beep
Error for 2 sec
Cause
Power frequency is other than 50 Hz. Unplug the power cord plug and check if the power frequency is 50 Hz.
Plug the power cord in 50 Hz power source and see If "E1" appears. If the error
code is displayed again even after the correct power source is provided, contact
the nearest service centre.
Thermistor Sensor which is supposed to Unplug the power cord and wait for more than 10 seconds. Plug the power cord
sense the temperature of the cavity again. If the symptom persists, contact the nearest service centre.
inside does not work properly.
(Thermistor Sensor open)
Thermistor Sensor which is supposed to Unplug the power cord and wait for more than 10 seconds. Plug the power cord
sense the temperature of the cavity again. If the symptom persists, contact the nearest service centre.
inside does not work properly.
(Thermistor Sensor short)
The oven cavity gets too hot due to Open the oven door and check if 1) the oven has been operating with no load or
excessive operation with no load or small too small load, 2) the air filter is placed in a wrong position, or 3) any blocking
load, or due to some blocking materials materials exist around the Air Exhaust. Cool down the oven (for approx. 30 min)
around the Air Filter or Air Exhaust at the under the normal temperature. The oven is back to normal when the error code
back of the oven. "E3" disappears and "ON" appears again in the display window.
Unplug the power cord, remove the blocking materials around the ventilation
openings, cool down the oven (for approx. 30 min) sufficiently, plug the power
cord in again and check if the error code appears again.
If the symptom persists even when the oven is cooled down sufficiently, contact
the nearest service centre.
The circuitry inside the oven is not Unplug the power cord and wait for 10 seconds.
working correctly. Plug the power cord in again and check if the error code "E41" appears again. If
the symptom persists, contact the nearest service centre.
The circuitry inside the oven is not Unplug the power cord and wait for 10 seconds.
working correctly. Plug the power cord in again and check if the error code "E42" appears again. If
the symptom persists, contact the nearest service centre.
8
Remedy