Setting The Alarms - Technoline WT 482 Manual De Instrucciones

6. Press SET again or if no key pressed for approx. 10 seconds to exit the setting mode.
Note: when 12-hour time format is selected, the PM LED will appear on the lower middle time display
to indicate the afternoon time; there is no AM indicator.

SETTING THE ALARMS

1. Press AL 1.2 / ON.OFF once, the A1 LED and the hour digits flash. Press
Alarm 1's hours. (hold to advance rapidly).
2. Press AL 1.2/ ON.OFF again to adjust minutes. Press
(hold to advance rapidly).
3. Press AL 1.2/ ON.OFF again, LED displays "OFF" (alarm off). To select wake to sound
sources, press
rd = wake-by-radio
bu = wake-by-buzzer
OFF = alarm off
4. Press AL 1.2/ ON.OFF again, the A2 LED and the hour digits flash. Press
Alarm 2's hours. Repeat step 2 and 3 above to set alarm 2.
5. Press AL 1.2/ ON.OFF again or no button around 10 seconds to exit alarm setting mode.
When wake-by-radio or wake-by-buzzer is selected, the related alarm is turned on, indicated
by appearance of the A1 and / or the A2 LED on the left side of the display.
Note: Alarm function just operates at AC mode only.
STOPPING AND RESETTING THE ALARM TO COME ON THE NEXT
DAY
When alarm 1 or 2 is sounding, the related A1 or A2 LED flashes. Press the RADIO/ SLEEP or AL
1.2/ ON.OFF once to stop the alarm and reset it to come on the following day. After that A1 or A2
icon keep lighting up on the display.
SNOOZE OPERATION (default snooze duration is 5 minutes)
When alarm is sounding, press
the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode, the
second alarm overrides the first alarm (the first alarm is reset to come on the next day).
USING THE HI-LO DIMMER
Press to adjust the brightness (LO / HI ) of the LED display. This can only be done when
the radio is off.
or to select :-
once, the alarm will be silenced and come on again after
or
or to set the Alarm 1's minutes.
or
to set the
to set the