Listening To The Fm Radio; Using The Sleep Timer - Technoline WT 482 Manual De Instrucciones

ADJUSTABLE LO DIM LED BRIGHTNESS
When LO dim brightness is selected by pressing
adjust your desired LO dim LED brightness. Rotate downwards to reduce and upwards to increase
the Lo dim brightness. Note: HI LED brightness is not adjustable.
SETTING UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.

LISTENING TO THE FM RADIO

1. To turn on the radio, press RADIO/SLEEP once, the display shows "ON" and then the radio
frequency readings in Mhz.
2. Press /
next clear station.
3. To adjust the volume, press VOL once, the display shows "L10", press
volume from L01 (minimum) to L15 (maximum)
4. Press
Remark: keep your radio away from fluorescent lamps or other electronic devices, which may cause
interference to the radio.
USING THE PRESET MEMORY
This clock radio features a total of 10 preset memories of FM stations. These allow you to preset your
favorite stations and access them quickly.
1. Turn on the radio and select a radio station you like to memorize.
2. Press and hold the SET until "MEM" LED appears and "01" flashes. Press SET once to
store Memory 1.
3. Press or
"MEM" LED appears and "01" flashes. Press
store Memory 02.
4. Repeat Step 2 to 3 to preset memories 3 through 10.
5. To access a preset station at any time, press the SET one at a time while the radio is on.
6. To edit a preset station, select another station and then repeat Step 2 to 4. This overrides
the original settings.

USING THE SLEEP TIMER

1. At normal time display mode, press the RADIO/SLEEP twice to enter the sleep mode. The SL
LED appear and the sleep time "05" (5 minutes) flash on the display.
to tune the radio to a desired station. Press and hold
to turn off the radio.
to select another station you like to memorize. Then press and hold SET until
once, turn the knob at the right side to
once, "02" appears. Press SET once to
/ to scan for the
/ to adjust