Publicidad
Idiomas disponibles
Idiomas disponibles
Safe work with the machine is only possible, if you read
these operating instructions completely and strictly
follow the instructions contained herein.
In addition, the general safety instructions in the
enclosed brochure have to be observed. Take part in a
practical introduction before the first use.Save all
warnings and instructions for future reference.
If the connection cable is getting damaged or cut during
the work, don't touch it, but instantly pull the plug out of
the socket. Never use the machine with damaged
connection cable.
When drilling in ceilings or walls make sure you will not
cut through electrical mains, gas or water pipes. Use
metal detection systems if needed.
Before you start working, consult a statics specialist to
determine the exact drilling position.
If drilling through ceilings, secure the place below,
because the core may drop out.
Pay attention that the tool is not exposed to direct rain.
Do not use the tool in an environment with danger of explosion.
§
§
Do not use the tool standing on a ladder.
§
Do not drill in asbestos-containing materials.
§
Never carry the tool at its cable and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Only
insert the plug into the socket when the tool switch is OFF.
§
Modifications of the tool are prohibited.
§
The machine should only run under supervision of. Pull the plug and
switch the machine off if it is not under supervision, e.g. in case of
setting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
§
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
§
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the connecting cable or plug.
§
Power tools have to be inspected visually by a specialist in regular
intervals.
§
Always lead the cable to the back, away from the machine.
§
When using the drill, cooling water is never allowed to get into the
motor and electrical parts.
§
Overhead-drillings only with suitable safety measures (water collection).
After an interruption of your work, only switch the machine on again
§
after having checked that the drill bit can be turned freely.
§
The tool may be used with the drill rig only.
20
Publicidad
