Logitech
®
QuickCam
®
Installation
5
Using .the .Camera .Stand
1 .
Remove .the .camera .from .the .base . .
2 .
Connect .the .stand .to .the .base . .Carefully use the alignment features to connect the stand easily
to the base.
3 .
Connect .the .camera .to .the .stand . .Carefully line up the connectors on the stand with the
connectors on the camera.
4 .
Do .not .carry .the .camera .by .the .stand . .The base could detach from the stand, and the base
could get damaged if it were to hit the floor. Move the unit by holding on to the base and stand
at the same time.
English
Camera .bottom
Line up connectors
Line up connectors
Base .top
Stand .top
Correct: .Hold base and stand
Stand .bottom
to move camera.
Incorrect