Remote Control; Cleaning And Maintenance - Melchioni Family VOLCANO Manual De Instrucciones

Press this button repeatedly to select the duration of the product operation before the automatic shutdown.
The duration can be selected from 1 to 12 hours at one-hour intervals; the display indicates the selected
duration. To cancel the timer function, select the value "00": the device will operate continuously until
deactivated with the ON / OFF button.
SWING
Turn the horizontal swing function on or off. When activated, this function directs the air flow to the right
and left slowly and alternately, for better heat diffusion.
BATTERIES REPLACEMENT
The remote control is powered by a lithium button battery (CR2025). If the remote control does not work,
replace the battery as follows:
1. Turn the remote control over and press the tab to right (A)
2. Pull out the battery compartment (B)
3. Replace the battery with the same type, be sure the positive side is facing up (C)

CLEANING AND MAINTENANCE

Caution: before cleaning the appliance, turn it off, disconnect the plug from the socket and wait until it has
cooled down.

To clean the body, use a soft, damp cloth; do not use metal wool pads or abrasive products.

Do not immerse any part of the appliance in water or other liquid: if this happens, do not immerse your
hand in the liquid but first disconnect the power supply. Carefully dry the appliance and check that all
electrical parts are dry: if in doubt, contact professionally qualified people.
 To avoid the risk of electric shock, never immerse the plug, cable and appliance in water or other
liquid.

Periodically clean the air outlet and inlet grilles, eliminating fluff, dust or other deposits, in order to get
good performance and operation; carry out the operation after disconnecting the plug from the socket.
If necessary, remove the accumulated dust with a vacuum cleaner.

REMOTE CONTROL

ON/OFF
Press to switch the unit on or off.
MODE
Press MODE to select the operating mode: high heating, low heating or ventilation
only (fan).
TEMP+ and TEMP -
Press repeatedly to increase (+) or decrease (-) the desired room temperature. After
pressing the TEMP button, the displayed value will flash for 3 seconds, after that the
appliance shows the room temperature again. When the desired temperature has
been reached, the appliance will switch to fan mode.
TIMER
16