Silverline 305706 Manual Del Usuario página 10

GB
Troubleshooting
Problem Possible cause Solution
Clean battery socket of Battery Charger (11) and Battery contacts and fully slide
Battery not correctly connected to Charger
Red LED does not illuminate to
on to Charger
indicate the Battery (8) is
correctly charging
Battery Charger not powered Recheck mains connection
Battery not being fully charged Recharge Battery
Battery pack has low capacity
Battery pack has been charged over 100 times and capacity This is normal for battery packs . Contact your Silverline dealer to purchase a
has started to reduce replacement battery pack
Drill driver cannot be switched ON The Forward/Reverse Switch (6) may be in the middle Slide the Forward/Reverse Switch to the forward or reverse positon, see 'Direction
(Trigger Switch (14) does not move) ('locked') position (Fig . IV) control' section
Battery completely discharged Recharge battery or replace with a fully charged battery
Drill driver does not start when
Defective Battery Replace Battery
Trigger Switch is depressed
Tool defective Contact your Silverline dealer or authorised service centre
10