Installation Instructions - LES PETITS CHAMPS CAVC20 Manual De Usuario

Refrigerador de vinos –20 bottiglie
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
The compressor consists of an electric motor and a
compression device. Due to the heat produced during the
compression of the refrigerant, it is possible especially in
summer when the ambient temperature is higher that heat is
emitted by the cellar. All of these phenomena are normal.
To reduce some noises:
First, make sure your cellar is on a level surface.
Location is important, do not lean the cellar against the wall.
The bottles must be correctly loaded to avoid parasitic
vibrations.
The noise may come from the circulation fan, check that
nothing is interfering with its operation.

INSTALLATION INSTRUCTIONS

Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for approximately 4 hours. This will reduce
the possibility of a malfunction in the cooling system from improper handling during transportation. Clean the interior
surface with lukewarm water using a soft cloth. (Cleaning instruction on page 9)
Installing Your Wine Cooler
This wine cooler is designed to be free standing only, and should not be recessed or built-in.
Allow 5 inches of space between the back and sides of the wine cooler, which allows the proper air ventilation. Adjust
the feet to keep the wine cooler level. Locate the wine cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Ambient temperature below 5°C or above 32°C will hinder the performance of this appliance.
This unit is not designed for use in a garage or any other outside installation.
Avoid locating the wine cooler in moist areas.
Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized service center.

Publicidad

Tabla de contenido
loading

Tabla de contenido