Recommendations For Use - Expondo MSW-EPR-710 Manual De Instrucciones

IMPORTANT: Starting with the smallest possible depth value and
increasing it gradually until the optimum setting is achieved and a
satisfactory result is obtained is recommended. A smooth surface
finish can be achieved at the shallowest depth of cut.
3.3.4

Recommendations for use

a) Guide the router with both hands forward on the workpiece
surface, exerting slight but steady pressure on the entire foot (F).
b) When working on the edge of the workpiece, hold the machine
parallel to the edge of the workpiece, and make sure that the
router foot is as close to the workpiece as possible.
c) Work with the machine on flat surfaces in such a way that the
tool and the cutting head always touch the unfinished surface as
shown in the picture below, so that the gaps will be narrow.
The gaps can then be closed by reducing the depth of the axial
cutter to 0 mm and moving the shoe with the cutting head over
the machined surface.