before initial use
Carefully clean the jug and permanent filter with hot, soapy water. Rinse with
•
clean water and dry carefully.
Fill the tank with cold water up to the maximum level indicated (6 cups).
•
Run the coffee machine for two cycles using only water (no coffee) to thoroughly
•
rinse it through. Pour away the hot water collected.
use
Open the lid and fill the water container with cold water using the jug. Use the
1.
graduations on the jug or water tank.
!
Never let the water level in the tank drop below the minimum mark
(3 cups) or go above the maximum mark (6 cups).
Either insert a No. 2 paper filter into the filter holder or use the permanent filter
2.
provided.
Fill it with the desired amount of ground coffee (typically 1 teaspoonful of ground
3.
coffee per cup).
Close the filter holder by turning it in the opposite direction until it clicks. This
4.
sound means the filter holder is in the right position.
Place the jug on the hotplate and press the on/off button. The power light comes
5.
on.
The coffee begins to percolate into the jug after a few seconds.
6.
Your coffee machine is fitted with an anti-drip system which allows you
to remove the jug for a short time while the coffee is brewing so that
you can serve yourself a cup. When you take the drug off the hot plate,
the flow of coffee is temporarily interrupted. Return the jug to the plate
within 30 seconds so that the filter does not overflow.
The hotplate stays hot until the appliance is turned off. Allows the coffee to be kept
7.
hot for 40 minutes. After this time, your coffee machine turns off automatically.
18
!
Do not open the cover when the coffee is brewing. Steam and scalding
water may be ejected: burn risk!
The jug gets hot when the appliance is in use. It should therefore only be
picked up by its handle. Do not touch the hot surfaces of the appliance.
If you want to turn off the appliance manually, press the on/off button. The
8.
power light turns off.
19