VIA P4M800 Pro Guia De Inicio Rapido página 8

3.2 DDR2 Memory Insertion
The mainboard accommodates two 240-pin DDR2 DIMM sockets:
• Supports up to 2.0GB of 400/533MHz DDR2 SDRAM.
• Supports non-ECC memory and non-Registered DIMMs only.
•
DDR2 SDRAM supports 256, 512MB and 1GB DIMM modules.
• Supports DRAM configurations defined in the JEDEC DDR2 DIMM specification.
Memory Installation :
To install, align the notch on the DIMM module with the connector.
Press straight down as shown in the figure until the white clips close and the
module fits tightly into the DIMM socket.
3.3 VGA and PCI card installation
This mainboard is equipped with on-chip graphics engine, you may connect a VGA monitor directly
to its rear port. However, if you need to install VGA card follow the steps below.
To install a VGA card into the VGA slot or a PCI expansion card:
1. Remove the bracket (on the PC case) for the slot you intend to use.
2. Firmly press down the card into the slot until it is completely seated. For a VGA card ensure
the VGA slot clicker is locked as shown in the picture below.
3. Secure the card's bracket to the PC case with a screw.
The AGP slot supports only newer VGA cards with 1.5V specifications.
8
Notch