m-cro MICRO X10 Traducción Del Manual Original página 11

It is recommended to fully charge the battery before using the scooter for the rst
time.
Charge the battery at least once every 3 months even if the product is not in use.
Failure to do so may results in batteries that cannot longer accept any charge.
Do not modify the electric scooter or install incorrect accessories as this will put
your safety at risk.
The use of unauthorized accessories may result in serious injury or damage to the
electric scooter.
'Customization' or 'Tuning' of the electric scooter is forbidden.
Do not hang items such as bags on the handlebar, as this will have an adverse e ect
on the handling characteristics.
Incorrect tightening of screws may lead to material fatigue. Screws become so
when they are subjected to excessive stress and may tear. This increases the risk of
accidents and injuries. Always use a torque spanner to tighten the screws.
Self-locking xings can lose their e ectiveness a er several months.Regularly
check the tightening of the various bolted elements, in particular the wheel axles, the
folding system, the steering system and the brake sha .
Always consult a specialist for repairs to the drive system.
Make sure that the bearings are properly maintained at all times.
The wheels may wear over time and should be replaced if necessary.
Eliminate any sharp edges caused by use.
Please contact the o cial Micro distributor in your market for further information
regarding the followings:
Lubrication recommendations: locations and frequency of lubrication,
recommended lubricant.
The method for adjusting the brakes and recommendations concerning the
replacement of friction components.
Method for adjusting or setting all of the components that would need to be
adjusted regularly or a er replacement of a part.
Where to nd a quali ed maintenance shop for items that cannot be done by
oneself (e.g. replacement of wear parts, electronic components, tightening torques
etc.)
*NOISE EMISSION
The A-weighted emission sound pressure level is less than 70 dB(A).
WARNING
for setup, maintenance and repair
11