GB
Stop the music playback on the Bluetooth
the streaming.
To start or stop music playback via the Tela, press the
multifunction button (5) once. During music playback, the LED
blinks blue.
By using an 3.5 mm jack cable, you can also use Tela as wired
headphones when it is turned off. To do this, connect the cable
to the 3.5 mm line-in port (7) of Tela and the audio source, start
music playback on the audio source.
NOTE: The buttons on the Tela have no function when
using an audio cable.
Music control
To play or stop music, briefly press the multifunction key (5).
To skip to the previous title, briefly press the volume- key (6).
To skip to the next title, briefly press the volume+ key (4).
Note: The mobile phone must support the A2DP and AVRCP
profile for music streaming and control. The buttons have no
function when using the wired connection. Use the audio source
to control the music and volume.
Hands-free features
With its built-in microphone and intelligent noise reduction,
the Tela is perfectly suitable for phone calls.
Answer/ending calls
To accept an incoming call, briefly press multifunction button (5).
To end an ongoing call, press and hold the multifunction button
(5).
Redial
Press the multifunction button (5) twice to redial the last dialled
number.
Volume setting
To increase the volume, press and hold the Volume+ key (4)
until the desired volume is reached.
To decrease the volume, press and hold the Volume- key (6)
until the desired volume is reached.
3
source to interrupt
®
Technical data:
• Wireless Audio Version 5
• Profiles: Headset, Handsfree, A2DP, AVRCP
• Range: approx. 10m
• Input: 5V DC
• Loudspeaker diameter: 40mm
• Sensitivity: 110dB ± 3
• Impedance: 32 Ω± 15%
• Built-in high performance microphone
• 3.5 mm audio line-in connector
• Status LED: Blue/Red
• Micro USB charging port
• Battery Type: 300 mAh Li
• Typical charging time: 1.5 hrs.
• Operating time: Up to 10 hrs.
• Weight: 169g
Safety advice:
• Do not open the device
• Do not hold the device under water
• Keep it safe from humidity
• Do not connect the adapter to the device by using force
• Keep the device away from children
• Disconnect electronic devices from the power when not using
them for longer time.
• Do not use the device when it has visible defects.
"Risk of hearing damage: To avoid hearing damage,
use the headphones only for short periods at high
volume. Set an appropriate volume. The higher the
volume, the faster hearing damage can occur. Observe the
following guidelines when using headphones: Listen only at an
appropriate volume and for an appropriate amount of time. Make
sure that you do not continuously increase the volume level even
after the familiarisation period. Set the volume only high enough
so that you can still perceive ambient sounds. Excessive sound
pressure from earphones and headphones can cause hearing
damage."
No liability is accepted for any damage caused by incorrect
operation.
In case you need technical support, please contact our
support-team by e-mail under service@fontastic.eu.
GB
4