General Operation - auna SELECT Manual De Instrucciones

EN

GENERAL OPERATION

After the initial setup, the device can be used in most modes. To select a
mode, press the SOURCE button until the desired mode is displayed on the
screen. Press SELECT to select the desired mode. The last channel or track
selected in this mode is selected. If this is not possible, the device searches
for relevant channels, networks or requests you to make a valid entry. The
modes are described in detail later in the operating instructions. In all
playback modes, the controls for volume adjustment, mute and play/pause
are the same.
Menu navigation
The rotary control is the main control to select the different menus and
options. Turn the rotary control to move up or down in the menu. Press
the control dial when the desired option is highlighted to confirm your
selection. All menus and lists function as a loop, which means that if you
continue to turn the rotary control at the first or last item, you move to the
other end of the menu/list. So if you turn the rotary control to the left at
the first entry, you will get to the last menu entry, etc. The symbol ">" is
displayed on the right side of the screen if there are other options above or
below the visible options.
To access the main menu in a particular mode, press the MENUbutton. Press
the BACK button to return to the previous option in the menu. Press the
MENU button again to exit the menu. Each mode has its own mode menu
with specific options. For example, the FM menu has a search setting and an
audio setting.
46