Technical Parameters - EGAmaster 57511 Manual De Instrucciones

ENGLISH
Nuts and bolts are widely used in industrial production. In the open air, high temperature or
corrosive atmosphere, a lot of nuts and bolts oxidize; also some threads are destroyed due to
being smashed. Generally, it's very difficult remove the nuts.
Presently, the method for cutting the nuts is used welding combustion, however, in the special
working environment, it's forbidden to use fire or electricity, such as petrochimie, oil companies,
that is, potentially explosive environments.
Our company has succesfully developed a hydraulic nut destroyer, fast, safe and with high
efficiency to solve problems.
COD.
57511
57512
57513
57514
NOTE: The maximum hardness of the nuts to be cut should be less than 44HRc.
INSTRUCCIONES DE USOINSTRUCCIONES DE USO
1. Connect the nut destroyer to the pump and close the pump release valve.
2. Place the nut destroyer head over the nut with her corresponding measure. See table
NOTE: The incorrect placement of the nut destroyer over the nut may cause malfunctions of
the item and the breaking of the blade.
NOTE: Before starting, add oil for cutting tools at the cutting edge of the blade to prevent
wear or break.
3. Operate the pump until the cutter blade cuts through the nut.
4. Open the release valve to retract the blade to its initial position.
HYDRAULIC NUT DESTROYER

TECHNICAL PARAMETERS

M
M6-M12
M12-M16
M16-M22
M22-M27
10-19
19-24
24-32
32-41
Ton
5
10
15
20
5