EGAmaster 57511 Manual De Instrucciones página 6

5. Remove the nut destroyer and realize the same process putting the blade on the
opposite place of the nut. Then, nut will break in two parts.
6. Finally, remove the nut destroyer and the broken nut.
1. Disconnect the nut destroyer of the manual pump.
2. Remove the screw from the side of the nut destroyer body.
3. Unscrew the head of the nut destroyer.
4. Remove the spring and later the setscrew from the side of the cutting blade that it
prevents the release of the blade.
5. Pull the cutting blade and replace it.
6. Insert the setscrew described in step 4 and later the spring.
7. Screw the head of the nut destroyer.
8. Align the blade to match her guide with the hole of the lateral screw of the nut destroyer.
9. Insert the lateral screw of the nut destroyer.
WARNING: Not to be used on square nuts.
a) The piston does not advance:
- Close the external drain valve completely.
- Check the oil level.
b) There is no pressure in the system:
- Check for leaks or the connections are tight perfectly.
6
Step 3
Rotate the nut destroyer through 180 degrees
CUTTING BLADE REPLACEMENT
SOLUTION TO POSSIBLE MALFUNCTION
Step 5