universalblue UCBJE73L-18 Manual De Instrucciones página 29

1. Remove the two screws that fix the upper hinge; Remove the top
hinge, disassemble the door and set it aside carefully.
2. Remove the three screws that fix the hinge on the lower right
side of the appliance, as it is shown in drawing 2; remove the top
hinge and the adjustable foot under the lower hinge under the
right side of the cabinet; At the same time, use a wrench to
remove the screws that fix the hinge shaft, remove the hinge
shaft down; Then remove the adjustable foot on the lower left
side below the left side of the cabinet.
3. Screw the adjustable foot that is on the left side previously to the
corresponding position on the right side under the cabinet; turn
the hinge down 180 degrees and fix the hinge shaft down into the
hole in the lower hinge, then turn the hinges and screws hard; Do
the same for the adjustable foot that is on the right side
previously to the corresponding position on the left side under
the cabinet; Then I turn the three screws that fix the lower hinge
firmly.
4. Place the door in the correct position and make sure that the
hinge axis down and the hole in the shaft on the lower left side of
the machine are properly fixed and connect correctly; turn all the
screws with force (as shown in daigram 6); then, fix the top
flange with screws. Finally, the process of changing the direction
of the door is done.
29