Drain Connection; Electrical Connection - universalblue ULLBL45-20 Manual De Instrucciones

CONNECT THE DEVICE TO THE WATER AND POWER SUPPLY
The connection to the water and electricity supply may only be carried out by a
qualified technician.
The dishwasher must not be above the water hoses or the power cord.
The device must be connected to the water supply by means of new pipes. Do not use
old pipes.
WATER INLET HOSE CONNECTION
CONNECTING THE WATER OUTLET HOSE

DRAIN CONNECTION

The drain connection should be between 50 cm (minimum) and 100 cm (maximum)
from the bottom. The water drain hose must be clamped.

ELECTRICAL CONNECTION

Before inserting the plug into the power outlet, make sure that:
• The socket is earthed and complies with current regulations.
• The plug can support the maximum load of the appliance, which is indicated on
the product label.
• The voltage is within the values indicated on the product label.
• Do not use extension cords or multiple plugs.
Connect the cold water supply hose to a 3/4
(inch) threaded hose and make sure it is secured.
If the water pipes are new or have not been used
for a long time, let the water run to make sure it is
free of impurities.
Place your machine's drain hose into the drain pipe
without bending.
If the length of the hose is not sufficient, please
contact the supplier to request an extensión. Note
that the length of the hose should not exceed 4
meters, even when an extension is used. If the
drain hose is longer than 4 m, the dishes will not
be cleaned properly.
51