Using The Appliance For First Time; Adjusting The Water Softener - universalblue ULLBL45-20 Manual De Instrucciones

9. Program select button: Press the button to select the program. The "Eco wash"
indicator will flash if it's connected to the power. Push the button to switch the
programme from "Eco"--"Light"-- "Crystal"--"Rapid"--"Pre-rinse"--"Intensive" and select
the one you want.
10. ON/OFF Button: To turn on/off the power supply.
5.

USING THE APPLIANCE FOR FIRST TIME

Before using the device for the first time, please:
A. Adjusting the water softener
B. Fill the salt tank
C. Fill the rinse aid dispenser
D. Fill with detergent
Please read the instructions carefully. Incorrect use of detergents and other
products used may cause irreparable damage to your dishes or appliance.

ADJUSTING THE WATER SOFTENER

The water softener is designed to remove minerals and salts from the water, which
would have an adverse effect on the operation of the appliance. The higher the content
of these minerals and salts, the harder the water. The softener should be adjusted
according to the hardness of the water in your area.
To adjust the descaler, follow the instructions below:
The amount of salt can be adjusted from H0 to H7.
No salt is required at the set value H0.
To adjust the descaler, follow the steps below:
1. Find out the tap water hardness value. Your water authority will be able to help you
with this.
2. The set value can be found in the water hardness table below.
3. Once adjusted, close the dishwasher door.
4. Press the "Power" button.
5. Press and hold the "Delay" button and press the "Program" button for 5 seconds.
The device will beep once and the indicator 'H' will appear on the display (H4 is the
factory default).
6. To change the value, press the "Delay" button as many times as necessary until the
desired value is set. Each time the button is pressed, a level is increased. When the
value reaches H7, pressing H0 again jumps the display.
7. Press the " Program " button to store the selected value.
Hardness grades
0-8
Water hardness
Range
Soft
Mmol/l
0-1.1 H0
Value to set in the
dishwasher
58