Tristar AC-5552 Manual De Usuario página 10

Instruction manual
The SLEEP mode can be activated while using COOL or HEAT
modes.
In COOL mode
• Press the SLEEP button while the unit is in COOL mode.
• After 1 hour the pre-set temperature will increase by 1°C. After 2
hours it will increase again by 1°C.
In HEAT mode
• Press the SLEEP button while the unit is in HEAT mode.
• After 1 hour the pre-set temperature will decrease by 1°C. After 2
hours it will decrease again by 1°C, then the temperature will be
kept constant for 10 hours. During this time all the LED indicator
lights will be dimmed, the fan speed will switch over to low for
silent operating and the speed cannot be selected.
TIMER (1 - 24 hours)
The timer has 2 ways of operating-
To automatically turn the unit OFF.
• Press the TIMER button.
• Press the UP and DOWN buttons repeatedly to set the delay OFF
time.
To automatically turn the unit ON.
• Press the TIMER button.
• Press the UP and DOWN buttons repeatedly to set the delay ON
time.
To cancel the timer press the POWER button or press the DOWN
button repeatedly until the display shows '''00''.
Automatic defrost
10
Frost may build up in the evaporator during operations at low
temperatures. When this happens the unit will automatically start
defrosting and the POWER LED will start blinking.
• If in COOL operating mode the unit will stop operating for 10
minutes and automatically restart in COOL operating mode.
• If in HEAT or DRY operating mode the unit will shut down for 20
minutes then spend 5 minutes defrosting.
Overload protection
In the event of a power loss, the compressor will require 3 minutes
before restarting.
Drainage
Manual drainage
• The unit will shut down when the water needs to be drained,
when this happens unplug the unit from the power supply.
• Move the unit to a suitable place for emptying the water pan at
the bottom of the unit.
• Unplug the water plug. Let the water run out into a container. The
unit may be tilted slightly backward to help the water escape.
• Once emptied, plug back the water plug and ensure that it is well
fitted.
• Plug in and restart the unit.