Adjusting The Handle Height - Makita LM001G Manual De Instrucciones

Adjusting the handle height

The handle height can be adjusted in two levels.
1. Hold the lower handle, and then turn the knob 90°
while pulling the knob on the lower handle to release
the locking pin. Perform the same procedure on the
other side.
1
Fig.27
► 1. Lower handle 2. Knob
NOTE: Supporting the handle makes it easier to
release the locking pin when pulling the knob.
2. Adjust the handle height, and then turn the
knob on both sides 90°. Make sure that the knobs are
securely fixed.
Fig.28
► 1. Knob
2
1
14 ENGLISH
Adjusting the traveling speed
Fig.29
► 1. Speed lever
The traveling speed can be adjusted with the speed
lever. To decrease the speed, pull the lever toward you,
and to increase the speed, turn the lever forward.
Using mulching plug
The mulching plug allows you to return the cut grass
to the ground without gathering the cut grass in the
grass basket. When you operate the machine with the
mulching plug, be sure to remove the grass basket or
discharge chute.
NOTICE:
When using the machine with the
mulching plug, make sure that the total length of
grass after cutting is 30 mm (1-3/16") or more, and
the cut length is 15 mm (9/16") or less.
Fig.30
► (1) 30 mm (1-3/16") or more (2) 15 mm (9/16") or
less
Using the discharge chute
The discharge chute allows you to discharge the cut
grass to the ground from the right side of the machine
without gathering the cut grass in the grass basket.
When you operate the machine with the discharge
chute, be sure to remove the grass basket and mulch-
ing plug.
1
2
1