Maintenance; Filter Replacement - Sagola 5000X Serie Manual De Instrucciones

40/41

14. Maintenance

In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the network.
Do not apply excessive force or inadequate tools for maintaining and cleaning the unit. Some
repairs must be done with special tools on some occasions. In these cases, you must contact the
Customer Service of SAGOLA. Any handling of this product by non-authorised personnel would
render the warranty null and void.
The unit must be overhauled on a periodic basis to check the status of its components and repla-
ce these when they are not in perfect condition.
IN ORDER TO OBTAIN THE BEST POSSIBLE RESULTS, ALWAYS USE
ORIGINAL SAGOLA SPARES. ENSURE TOTAL INTERCHANGEABILITY,
SAFETY AND OPERATION.

14.1. Filter Replacement

In order to replace these, proceed as follows:
Close the air valve leading to the unit. Discharge the pressurised air.
With the unit totally de-pressurised, disassemble the unit's deposit.
Disassemble the filter to be replaced, turning it anti-clockwise.
Insert the new filter and tighten it by turning it clockwise. Then assemble the deposit of the unit.
Sintered Bronze Filter
As a general rule, SAGOLA recommends
cleaning it with an adequate thinner
or its replacement every six months.
Unscrew lower section
Replace spare filter
Extract the filter
Grease and place lower section
ENGLISH
Clean the shaft
Place the strip and press the
activation button