2.
Connect and charge
Baby (camera) unit
WARNING
Strangulation Hazard. Children have STRANGLED in cords. Keep this cord out of the
reach of children (more than 1 meter or 3 feet away). Do not remove the tags from
the AC Adapters. Only use the AC Adapters provided.
Parent unit
A rechargeable battery is already pre-installed inside the parent unit. When fully
charged, you can move the parent unit without losing the link and picture from the
baby (camera) unit. When charging the battery for the first time, charge for at least
16 hours continuously.
Press and hold
Note
Use only the supplied power adapter (DC5V / 1500 mA).
Pair the baby (camera) unit to the parent unit
We have paired the baby unit to the parent unit in the pack. In case you want to pair
an extra camera, press and hold
voice prompt 'Ready for pairing' is heard.
3.
Wall mount the baby (camera) unit
1.
Mark the positions of 2 screw holes on the wall. Drill a screw hole at each marking.
2. Install the supplied wall anchors into 2 screw holes on the wall.
3. Insert the supplied wall mounting screws into the wall anchors.
4. Remove the desk stand by loosening the screw on the underside of the desk
stand.
5. Fix and fasten this screw on the baby (camera) unit and the wall mount bracket.
6. Hang the wall mount bracket on the wall mounting screws on the wall.
1.
Plug the DC plug of the power adapter into
the power socket on the rear of the baby
(camera) unit and plug the other end of the
AC adapter into the wall socket.
2. The baby unit turns on and the power
indicator lights up in blue and blinks in red
after 30 seconds if the parent unit has not
been powered up.
1.
Plug the DC plug of the power adapter into
the power socket on the side of the parent
unit and plug the other end of the AC adapter
into the wall socket.
2. Switch on the AC power.
3. Press and hold the power button on the top of
the parent unit to turn it on.
4. When the parent unit is fully charged,
appear steadily on the screen display.
on the rear of the baby (camera) unit until the
will
3