Power On/Off - Rollei HS Freeze 4s Manual De Instrucciones

Operation
30
Power on / off
– Switch on: Press and hold the power button for about 2 seconds
until the LCD screen will lights up and loads the menu system.
– Switch off: Press and hold the power button for about 2 seconds
until the LCD screen turns totally black.
TTL Mode
1. Enter Menu 1 and press the second function button repeatedly until the display
shows TTL on the LCD.
2. Press the third function button to change the sync mode. Choose between
normal mode or high speed mode.
3. Enter Menu 2 to set the channel and the group of the flash.
4. Choose the wireless remote control mode according to the trigger
that you are using.
5. The exposure value can be adjusted from -3.0 up to +3.0 directly on the flash
by rotating the power output wheel. The value can be adjusted by 1 f-stop
increment by pushing the power output wheel once and then turning it around
(clockwise to increase the value and counter clockwise to decrease the value).
The value can also be adjusted by 1/10 f-stop by just turning the power output
wheel without pressing.
Note: If you use a trigger the value of the flash will not be overwritten by the value
set on the trigger. For example if your flash shows an EV of +1.0 and your trigger
shows a value of +2.0, then the picture will have a real exposure value of +3.0.
If the flash shows an EV of +3.0 then you are able to even get a higher exposure
value by setting the trigger to also +3.0 and then the maximum exposure value of
+6.0 will be reached. The same goes for the negative exposure values.
ENGLISH