Turn Power On; State Of Charge Indicator - Rollei 58 Instrucciones

Turn Power On

59
Slide the power button to „ON" to turn on the
flash and slide the button back to „OFF" to turn
off the device .
In order to save battery power and avoid battery
leakage, the default settings are:
If the Flash Unit is turned on, but is not used
within 60 seconds, the flash will automatically go into standby . The flash can
be awaken by pressing any button . If the Flash Unit is not used for more than
30 minutes, the flash will automatically shut down .
If the Flash Unit will not be used for a long period of time it is recommended to turn
it off by the power switch and remove the batteries . Before removing the batteries
please make sure that the flash is turned off .
If the Flash Unit's capacitor is fully charged, the flash key button will light up, which
indicates that the flash is ready to trigger .

State of Charge Indicator

Please make sure that the flash key button is
shining before using the flash .
Use PC Sync to sync this flash by cable with the
camera .
USB Port for upgrading latest version of program .