Drill Bit - Bosch GSR18V-1330C Instrucciones De Funcionamiento Y Seguridad

2610056705 GSB18V-1330C 04-21.qxp_GSB18V-1330C GSR18V-1330C 5/3/21 7:00 AM Page 11
Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
Inserting Bits
Move reverse switch lever to the center
"OFF" position. Remove battery pack and
turn the mode selector switch to the
drilling
sleeve counter-clockwise viewing from
chuck end, and open chuck to approximate
drill bit diameter. Insert a clean bit up to
the drill bit flutes for small bits, or as far as
it will go for large bits. Close chuck by
rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 3). Move
forward / reverse switch lever to desired
position.
chuck to loosen or tighten bit. Friction
burn or hand injury is possible if
attempting to grasp the spinning chuck.
Belt Clip
position yourself to avoid entanglement
with surrounding objects. Unexpected
entanglement could cause the tool to fall
resulting in injury to the operator or
bystanders.
The belt clip accessory (11) will allow you
to conveniently attach your tool to your
belt. This feature will allow you to have
both hands free when climbing a ladder or
moving to another work area.
The belt clip can be attached to either side
of the tool by securing it with a mounting
screw. Always make sure you securely
tighten the mounting screw before use
(Fig. 4).
To use clip, turn tool upside down and
attach to your belt.
Assembly
position. Rotate the chuck
Do not use the power of
the drill while grasping
When the tool
attached to the belt,
FIG. 3
CHUCK SLEEVE

DRILL BIT

SCREWDRIVER BIT
is
11
CLOSE
OPEN
BIT HOLDER
(11)
FIG. 4