Motion BLINDS CM-40 Manual página 29

5 Pair a remote
Pair a remote control that is suitable for vertical application.
Shortly press the program button on the
5.1
motor. The blind will start stepping, indicating
that program mode has been activated.
(The blind remains stepping until the program
mode is de-activated.)
Select a desired channel for the blind using the
5.2
channel selection button on the remote control.
Press the pair button on the back of the remote
5.3
control to pair the blind to the selected channel.
The blind will shortly stop stepping indicating
that the remote has been paired to the blind.
Shortly press the program button on the motor.
5.4
The blind will stop stepping, indicating that program
mode has been de-activated.
Repeat steps 5.1 - 5.4 to remove a blind from
a channel.
6 Check direction of rotation Slide motor
M O TI O N CM - 4 0 D C V E R TIC AL MOT OR
Channel
Selection
Up
Down
Short
press
Channel
indicator
button
Shortly press the right button to check if the
6.1
blind moves the right way: away from the
motor. If the blind moves the other way, the
rotational direction must be changed.
Activate program mode by shortly pressing the
6.2
program button on the motor.
Simultaneously press the up and down button
6.3
to change the direction of rotation.
Shortly press the program button on the
6.4
motor. The blind will stop stepping, indicating
that program mode has been de-activated.
Pair
11