Frequently Asked Questions - Motion BLINDS CM-40 Manual

Frequently Asked Questions

Problem
Blind does not work.
Pull function does not work.
Slats are able to tilt fully at the
packside of the system.
Multiple blinds respond to a
remote. (Unable to program a
single blind)
Blind moves in the opposite
direction.
The blind keeps moving left and
right.
Unable to pair the blind with
bluetooth.
M O TI O N CM - 4 0 D C V E R TIC AL MOT OR
Cause
Remote battery is empty. (LEDS of remote
are flashing rapidly.)
Remote battery is inserted incorrectly.
Radio-frequency interference
The distance from the remote to
the motor is too far.
The remote is not connected to
the blind.
No end limits are programmed.
The end limits are not set correct.
Multiple blinds are paired with a single
channel.
The rotational direction has been
set incorrectly.
The blind is in program mode.
The blind has been paired to a bluetooth
device.
Solution
Replace the battery in the remote.
See the manual of the remote.
Replace the battery in the remote.
See the manual of the remote.
Make sure that the antenna of the motor is
out of the way of metal objects.
Move closer to the motor.
Pair the remote with the motor.
See step 6.
Program end limits.
See step 4.
Reset the blind and initialize the blind.
Make sure the blind moves away from the
packside. See step 4.
Pair the blind with a free channel to
program or use single select to program
the blind.
Change the rotational direction.
See step 7 and step 8.
Press the program button on the motor
to exit program mode.
Reset the bluetooth connection or use the
QR code to pair another device.
17